Icom IC-M1V Instruction Manual page 23

× Self check function
"SELF CHECK"
The self check function checks trans-
ceiver conditions by itself and informs
you in case of problem is found. Follow-
ing contents are checked after power
ON, then turning into operation mode
when no problem is found.
• PLL lock
(both transmit and receive)
• Temperature
• Connected battery voltage
• Water intrusion
Push
Self check
function ON
Push
Self check
function OFF
(default)
Scrolls the channel
comment, "
× Scrambler unit selection
"SCRAM UNIT"
This item appears only when voice
scrambler unit is installed.
Selects installed voice scrambler unit,
otherwise the voice scrambler function
not performed properly.
".
SET MODE
× Scrambler code
"SCRAM CODE"
There are 128 codes (00 to 127) avail-
able with UT-98 or 32 codes (00 to 31)
available with UT-122 for programming.
In order to understand one another, all
transceivers in your group must have
the same unit* and scramble code.
*Different scrambling system is used be-
tween UT-98 and UT-122, therefore, the
same unit must be used in your group .
8
19