Driving Your Mazda
Starting and Driving
NOTE
If any one of the following operations is performed after the engine has been
l
automatically stopped, the engine will restart automatically even though the brake
pedal is not released.
The i-stop OFF switch is pressed for several seconds.
l
The temperature control dial for the air-conditioning system is set to the maximum
l
hot or cold position.
The windscreen defroster switch is on.
l
The driver intends to get out of the vehicle (driver's seat belt is unfastened and any
l
door or the liftgate is opened).
The brakes are released slightly on a slope and the vehicle begins to move.
l
The accelerator pedal is depressed while the shift lever is in the D/M position (not
l
second gear fixed mode).
The shift lever is shifted to the R position.
l
The shift lever is shifted from the N or P position to the D/M position (not second
l
gear fixed mode).
The steering wheel is operated with the shift lever in the D/M position (not second
l
gear fixed mode).
The shift lever is in the D/M position, second gear fixed mode.
l
If any one of the following vehicle conditions occur after the engine has been
l
automatically stopped, the engine will restart automatically even though the brake
pedal is not released.
There is a large difference between the cabin temperature and the temperature set
l
for the air-conditioning system.
Two minutes have elapsed since the i-stop function started operating.
l
The battery power is depleted.
l
If any one of the following occurs, the length of time the engine is stopped
l
automatically could be shorter or the length of time required before i-stop functions
again could be longer.
The ambient temperature is high or low.
l
The battery power is depleted.
l
The power consumption of vehicle equipment is high.
l
The i-stop function does not operate when the ambient temperature is extremely high
l
or low.
The engine may not stop automatically for a while after the battery leads are
l
reconnected after temporarily disconnecting them. In addition, if the battery is
replaced, the i-stop system will need to be reset and checked to make sure it operates
correctly. When replacing the battery, consult an expert repairer, we recommend an
Authorised Mazda Repairer.
5-10