Connection S1037 - GR-12L SUMD+T
Antenna
Power supply
10 / 16
Connect your Flybarless system to the SUMD connector.
You can connect HoTT sensors to the Telemetry port.
The colors of both cables mean:
brown cable (-) power supply
red cable (+) power supply
orange cable (signal) telemetry or SUMD
Connection Telemetry
You can connect the power supply to the receiver through one of the
two cables. Always use only one cable and one power supply. Make
sure that the power supply voltage is not higher than 8,4V DC.
Connection SUMD
S1037_S1012_jh_V1