Using Remote Commands - Radio Shack TAD-1026 Owner's Manual

43-786.fm Page 27 Monday, August 16, 1999 8:02 AM
USING REMOTE
COMMANDS
To use the remote commands, you must
enter the remote operation security code
within 8 seconds after the TAD answers
the call. After the TAD beeps once to
verify you entered the code correctly,
enter the number(s) for the function(s)
you want the TAD to perform.
Press:
00 Turn the answering system off.
01 Turn the answering system on.
The TAD beeps and plays
OGM1. (TAD is set to play
OGM1.)
02 Set TAD to answer with OGM2
announcement.
2 Play all messages.
3 Play new messages.
4 Monitor the room where the TAD
is installed. The room is moni-
tored for 15 seconds. Press 4
again for another 15 seconds.
You can repeat this for as long as
you like.
51 Delete all messages (except new
messages).
6 Stop playback and message
recording.
7 Record a memo.
To:
After you press 2 or 3:
Press: To:
81 Change OGM1.
82 Play OGM1.
91 Change OGM2 (after TAD is set
to play OGM2). (Press 6 when
finished.)
92 Play OGM2 (after TAD is set to
play OGM2).
#1 Change remote operation secu-
rity code.
#2 Change CBT Code.
# Skip OGM1 during playback.
Press:
5 Delete the current
message.
1 while message Replay the previous
number and day/ message.
time is playing
1 during message Replay the current
playback message.
3 Skip forward to the
next message.
6 Stop message play-
back.
To:
27