Related Manuals for Sentry P2B-ATEX
Summary of Contents for Sentry P2B-ATEX
- Page 1 Original Instructions Installation, Operation & Maintenance Manual Sentry P2B-ATEX Controller Sampler Controllers S-LS-IOM-00508-0 3-17...
- Page 2 Copyright © 2017 by Sentry Equipment Corp . All rights reserved . All product and company names are property of their respective owners . This document contains proprietary information . No part of this document may be photocopied or reproduced without the prior written consent of Sentry Equipment Corp .
-
Page 3: Table Of Contents
Customer Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10 Sentry P2B-ATEX Controller... -
Page 4: Safety Information
. Â NOTE Information that requires special emphasis . Â TIP Alternate techniques or clarifying information. SHALL: This word is understood to be mandatory . SHOULD: This word is understood to be advisory . Sentry Equipment Corp... -
Page 5: General Safety Precautions
. If the sample container is removed from the sampler, do not insert any body part or other item into the sample discharge port . Crushing will occur . Sentry P2B-ATEX Controller... -
Page 6: General Description
The Sentry® P2B-ATEX controller is a manually-operated explosion-proof sampler controller used to operate the Sentry RX, Sentry PR, or Sentry ISOLOK® samplers . The sampler controller is connected to a pneumatic solenoid . The sampler controller can be used to control the size and frequency of the sample . -
Page 7: Operation
ƒ When the timers are set, make sure the selector switch is in the OFF position before applying power to the sampler controller . ƒ TDR 113 is typically set to 5 seconds . ƒ TDR 115 is set at the time required between samples . ƒ TDR 104 should be set to 0 . Sentry P2B-ATEX Controller... - Page 8 An emergency stop, if required, shall be provided by others . Reset To reset the batch counter (CTR-106), place the HOA in the OFF position . Or, it can be done remotely by removing power from CR-142 . Sentry Equipment Corp...
-
Page 9: Maintenance
3. Clean the plastic bowl using warm water only . If the plastic bowl shows signs of cracking, cloudiness or other signs of deterioration, replace with a metal bowl . Consult Sentry Equipment Corp for replacement parts . 4. Lubricate the o-ring seal before reassembly . Tighten the element stud and/or bowl to 5-10 in lb . -
Page 10: Standard Warranty
ƒ Replacements Parts & Consumables—Order your replacement parts and consumables . ƒ Sentry ProShield Services – select from four ProShield Guardian service plans providing diff erent levels of support to protect your large system investments with regularly scheduled maintenance . - Page 11 This page is intentionally left blank . Sentry P2B-ATEX Controller...
- Page 12 Serving customers in more than 50 countries across six continents worldwide. sentry-equip.com 966 Blue Ribbon Circle North, Oconomowoc, WI 53066 U.S.A. | +1-262-567-7256 | support@sentry-equip.com...