Related Manuals for Zenith ZRF1
Summary of Contents for Zenith ZRF1
- Page 1 CODE POWER SEARCH CHAN PAGE SUBTITLE REPEAT PAGE DATE FLASHBK CHAN RATIO SURF SIGNAL HELP SD/HD I N PUT I N F O GUIDE MENU EXI T SKI P SCAN PLAY SCAN STOP PAUSE ZRF1...
-
Page 2: Table Of Contents
TV Punch Through Feature ......5 VCR/DVD Punch Through Feature ....5 Thank you for buying a Zenith remote and we hope it Code Setup ..........5 will give you many years of service. -
Page 3: Setup
Setup Setup, cont. Battery Installation TV Volume/Mute Punch-Through Feature 1. On the back of the remote, The TV Volume/Mute punch-through feature lets you push down on the tab and control the Volume and Mute function of your TV in any lift the cover off. -
Page 4: Button Functions
Button Functions, cont. Button Functions Some buttons on the remote might have functions that are referred to by different names on the device you are controlling. E.G. FLASHBK may be called , or RECALL may be called . These differences depend ENTER DISPLAY on the brand and model of your product. -
Page 5: Advanced Functions
Advanced Functions Advanced Functions, cont. DASH (-) Used to enter a channel number for multiple SIGNAL Shows the signal strength of the current channels such as 2-1, 2-2, etc. A broadcaster may channel. For digital over-the-air or satellite channels you transmit multiple programs on a single channel. -
Page 6: Dvd Functions
Advanced Functions, cont. Advanced Functions, cont. DVD Functions VCR/DVD Punch Through Feature SCAN+ and SCAN- buttons control the speed of Fast This remote lets you Punch-through to the last VCR or Forward and Reverse Playback respectively. DVD device used. Normally other types of remotes only punch-through (from another Mode) on the 6 VCR SKIP+ and SKIP- buttons respectively locate the buttons, to the device programmed under the VCR... -
Page 7: Code Entry
Code Entry Code Entry, cont. Direct Code Entry Programming with Code Search 1. Press and hold the button until the CODE SEARCH If your product does not respond after you have tried all red indicator stays on, then release the CODE the codes for your brand, or if your brand is not listed, button. -
Page 8: Brand Search
Code Entry, cont. Code Entry, cont. Code Search by Brand Brand Search Table Look up your brand in the appropriate column (TV, VCR, Lets you search for a code for a specific Brand within etc.). Look to see what digit (1, 2, 3, etc.) applies to your the Code Library for a particular manufacturer. -
Page 9: Code Identification Feature
Product Operation Code Identification Code Identification Feature After the batteries are installed and you have programmed the remote for the codes that operate your products, you can use your remote to operate a TV, VCR, The Code Identification Feature allows you to identify Satellite Receiver, DVD Player, etc. -
Page 10: Troubleshooting
Wireless Receiver Troubleshooting The remote transmits wireless Radio Frequency (RF) Remote does not operate your product. commands. The wireless receiver (included) receives these commands and converts them to regular Infrared • Press the mode button of the product you want to (IR) commands. - Page 11 Should a defect occur under normal operating conditions within 90 days from the date of purchase, ZENITH will provide a comparable replacement free of charge within the warranty period, to the original purchaser. Defective product must be returned, with the dated proof of purchase, to the place of purchase for replacement.