Related Manuals for MD SPORTS BLL084-087B
Summary of Contents for MD SPORTS BLL084-087B
- Page 1 MODEL: BLL084_087B VM Innovations ASSEMBLY INSTRUCTIONS ATTENTION DO NOT RETURN TO THE STORE Contact MD Sports Customer Service * For additional resources and Frequently Asked Questions, please visit us at themdsports.com...
- Page 2 LIMITED 90 DAYS WARRANTY This product is covered by a limited warranty that is effective for 90 days from the date of purchase. If, during the limited warranty period, a part is found to be defective or breaks, we will offer replacement parts at no cost to you, the customer. The only exceptions to the warranty include mainframes, table tops, playing surfaces, batteries or tools.
-
Page 3: Tools Required
TOOLS REQUIRED Power Tools Phillips Screwdriver - Not Included - Set Low Torque Standard (Flat Head Screwdriver) - Not Included Allen Key - Included High Torque over tightened CAUTION! Electric Screwdrivers may be helpful during assembly; however, please set a low torque and use extreme caution. - Page 4 BLL084_087B PARTS LIST FOR FIG. 1 FOR FIG. 1 FOR FIG. 1 FOR FIG. 2 Mainframe Left Leg Right Leg End Leg Panel FOR FIG. 1 FOR FIG. 1 FOR FIG. 2 Allen Key M8x35mm Bolt M8 Washer 3.5x18mm Screw FOR FIG.
- Page 5 BLL084_087B PRE-INSTALLED PARTS FOR FIG. 1 FOR FIG. 1 FOR FIG. 1 Square Nut with Screws T - Nut Fabric Pocket ASSEMBLY INSTRUCTIONS: 1. Find a clean, level place to begin the assembly of your Product. 2. Remove all the parts from the box and verify that you have all of the listed parts as shown on the Parts list pages. Carefully cut or tear the four corners of the box so that the bottom of the box can be used as your work surface.
- Page 6 FIG. 2 X 12 FIG. 1 Assembly Note: Go back and make sure that all connections are tight. CABINET DO NOT HOLD THE LEGS DO NOT LEAN THE HOLD TABLE TABLE ON ITS LEGS CAUTION: Two strong adults are recommended to turn the table over as shown. 1.
- Page 7 FIG. 3 NOTE: DO NOT lift the table by the pockets. If you move the table, do not lift it by placing your hands beneath the pockets and do not lean or put pressure on them. Do not lean or sit on the end or side rails as this may damage the table.
- Page 8 FIG. 5 Note: Place the Table Tennis Support (#17) onto the playfield and place the Table Tennis Tops (#15 and #16) onto the billiards surface. Then Insert the Net Posts (#18) and Net (#21) onto the Table Tennis Top. YOU ARE NOW READY TO PLAY! BLL084_087B www.themdsports.com (The last page)