Harman Kardon TU-940 Technical Manual page 5

7. MEMORY
Use to enter station into the preset memory or to start the Auto Preset Memory function. The
memory indicator blinks when the button is pressed. See page 10 for instructions on using the
memory system.
8. TUNE/P.SET
Press to light PRESET indicator. When the indicator is lit, the TUNING knob 10 can be used to
step through the preset stations in ascending or descending order. When the PRESET indicator
is not lit, normal tuning (auto or manual) is activated.
9. P.SET SCAN
Press to automatically step through each of the stations that has been preset into the memory.
Each programmed station will play for approximately five seconds. To stop at a desired station,
press again, while the station is playing.
10. TUNING
This knob has a number of functions, although it's primary use is to select stations. In normal
use, turn the knob in either direction to move through the selected band to find a station. When
the TUNED indicator lights, the station is properly locked in.
A number of automated tuning methods are also available:
In the FM mode, when AUTO/MAN 17 is pressed so that the AUTO indicator is lit, turning the
tuning knob clockwise will cause the tuner to scan higher frequencies. When turned
counterclockwise, lower frequencies will be scanned. The tuner will stop at the first station that
has acceptable signal strength. Turn the knob again in the same direction to tune to the next
available station.
8
When TUNE/P.SET is pressed so that the PRESET indicator is lit, turning the TUNING knob
10 will move the tuner up or down through the stations programmed into the unit's memory. The
12 11
Tuning Knob also functions as a selector for PTY and Character functions. See
descriptions of these functions on page 13 and below.
11. CHARACTER
Permits you to enter or modify the name of any station, which is not broadcasting in RDS.
To enter a name, press CHARACTER once. A line will flash under the first space in the display,
Turn the tuning knob until the desired character (letter, number or symbol) appears.
Press again to move to the next space. Repeat this procedure until the name is spelled out,
using the tuning knob to select a character and the Character button to move to the next space.
When the last character has been programmed, press MEMORY 7, and then select memory
location (1-30) using the NUMBER keys 2.
The name may be called up at any time by pressing DISPLAY 14.
12. PTY
Press to select a particular PTY (Program Type) according to the information transmitted by an
RDS station. After pressing PTY, turn the TUNING knob 10 to select the program type for which
you wish to search.
For detailed RDS information, see page 12.
5