Setting The Maximum Number Of Portal Users; Specifying A Portal Authentication Domain - HP FlexNetwork 10500 Series Security Configuration Manual

Step
3. Configure an IPv6
portal authentication
destination subnet.

Setting the maximum number of portal users

Perform this task to control the total number of IPv4 and IPv6 portal users in the system.
If you configure the maximum total number smaller than the number of current online portal users on
the device, this configuration still takes effect. The online users are not affected but the system
forbids new portal users to log in.
To configure the maximum number of total portal users allowed in the system:
Step
1. Enter system view.
2. Set the maximum number
of total portal users.

Specifying a portal authentication domain

An authentication domain defines a set of authentication, authorization, and accounting policies.
Each portal user belongs to an authentication domain and is authenticated, authorized, and
accounted in the domain.
After you specify a portal authentication domain on an interface, the device uses the specified
authentication domain for AAA of all portal users on the interface, ignoring the domain names carried
in the usernames. This allows for flexible portal access control.
The device selects the authentication domain for a portal user on an interface in this order:
1. ISP domain specified for the interface.
2. ISP domain carried in the username.
3. System default ISP domain. For information about the default ISP domain, see
AAA."
You can specify an IPv4 portal authentication domain, an IPv6 portal authentication domain, or both
on an interface.
To specify an IPv4 portal authentication domain:
Step
1. Enter system view.
2. Enter VLAN interface view.
3. Specify an IPv4 portal
authentication domain.
To specify an IPv6 portal authentication domain:
Command
portal ipv6 free-all except destination
ipv6-network-address prefix-length
Command
system-view
portal max-user max-number
Command
system-view
interface interface-type
interface-number
portal domain domain-name
146
Remarks
By default, no IPv6 portal
authentication destination subnet is
configured, and users accessing
any subnets must pass portal
authentication.
Remarks
N/A
By default, no limit is set on the
number of portal users in the
system.
"Configuring
Remarks
N/A
N/A
By default, no ISP domain is
specified for IPv4 portal users on
the interface.