Axis 225FD User Manual page 7

Power connector block - for connection of a power supply. See Power connections, on
page 50.
I/O terminal connector - The I/O terminal connector provides the physical interface to one
solid state relay output, two digital inputs, RS-485/422 and GND. For more information,
see Unit Connectors, on page 47.
Network connector - The AXIS 225FD connects to the network via a standard network
cable, and automatically detects the speed of the local network segment
(10BaseT/100BaseTX Ethernet). This socket can also be used to power the AXIS 225FD via
PoE (Power over Ethernet). The camera also negotiates the correct power level when using
PoE.
Serial Number - This number is used during installation.
Control Button - This button is used during the installation using the AXIS Internet
Dynamic DNS Service (see the Installation Guide) or to restore the factory default settings,
as described in Advanced, on page 45.
LED Indicators
After completion of the startup and self test routines, the multi-colored Network, Status,
Heater, and Power LED indicators flash as follows:
Green
Amber
Network
Red
Unlit
Green
Heater
Red
Green
Amber
Status
Red
Unlit
Green
Power
Amber
Steady for connection to 100 Mbit/s network. Flashes for network activity.
Steady for connection to 10 Mbit/s network. Flashes for network activity.
Flashes rapid red, together with the Status indicator, for hardware error.
No connection.
Shows steady green if the connected power supply can deliver the correct voltage for
the heater (See Power, on page 58 of Technical Specifications).
Shows steady red if the connected power supply cannot deliver the correct voltage (i.e.,
the voltage is either too high or too low).
Shows steady green for normal operation. Can be configured to flash green at intervals
whenever the camera is accessed. See the online help for more information.
Shows steady amber during reset to factory default or when restoring settings.
Slow flash for failed upgrade (see Emergency Recovery Procedure, on page 44).
Rapid flash, together with the Network indicator, for hardware error.
When configured for "no flash" on camera access.
Normal operation.
Flashes green/amber during firmware upgrade.
AXIS 225FD - Product Features
7