Roper B4007B0 Use And Care Manual page 10

REMOVABLE OVEN AND BROILER DOORS REMOVABLE OVEN RACKS AND GUIDES
The oven and broiler doors can be removed for cleanmg
To remove:
1. Open the door fully and raise the release tab on each door hinge (see
Fig. A).
2. Rotate the release tabs toward the oven as far as they will go (see
Fig. 6). then close the door until you reach a pomt where the door
WIII hold a partly open positlon. This is the stop posltion.
3. Grasp the door firmly at the sides and rotate the lower edge of the
door away lrom the oven and lifl it off the hinge arms (see Fig. C).
To replace:
1. Slip the hinge arms into the upper end of the slots in the door.
2. Lower the door to the lully open positton and rotate the release tabs
to the onginal position (see Fig. D).
-- '.
F@.C
Be sure not to scratch the oven finish when installing or removing oven
racks.
To install:
1. Put the pegs on the end of the rack guide into the holes in the oven
back.
2. Lock Ihe front hook In the slot in the oven side.
3. Set the raised back edge of the oven rack on a pair of rack guides ~
so the hooks at the sides of the rack run underneath the rack guides. -
4. Push the rack in until you reach the bump in the rack, then lift the lront
of the rack a bit and push the rack all the way in.
To remove:
1. Pull the oven rack out. then up, in one motion.
2. Lift the front of the rack guide to unhook It from the oven wall and pull
out.
See the cleaning instructions on page 9.
RACU HOOK
RACU
BUMP