One for All URC-8350 Instruction Manual page 8

(How to copy functions from your original working remote
The URC-8350 comes with a complete library of pre-programmed codes. After
you have set up the URC-8350 for your device, you may find that there are one
or more keys that you had on your original remote, which do not have a place
on the URC-8350 keypad.
As a convenience, the URC-8350 offers a special Learning feature that
allows you to copy any function from your original remote control onto the
keypad of the URC-8350.
Before you start:
- Make sure your original remote control is working correctly.
- Make sure neither your URC-8350, nor your original remote control is
pointing at your device.
Example: To copy the "mono/stereo" function from your original TV
remote onto the "LAST" key of your URC-8350.
1. Place both remote controls (the URC-8350 and your original) on a flat
surface. Make sure the ends which you normally point at your device
are facing each other. Keep the remotes at a distance of 2 to 5 cm.
2.
3.
4.
5.
6.
7. If you want to copy other functions within the same mode, simply repeat
steps 5 and 6 pressing the next key you want to copy by learning. If you want
to copy other functions to a different mode, then repeat from step 4
onwards and press the applicable mode key.
8.
9. Learning is mode specific. To access your learned function, press
the appropriate device key first.
- The URC-8350 can learn approximately 25 - 40 functions (depending on the
function to be learned). Memory full will be indicated by two long blinks.
- You can replace a learned function by placing another learned function on
top.
- Upon changing the batteries, your learned functions will be retained.
WWW.ONEFORALL.COM
The Learning Feature
onto the ONE FOR ALL URC 8350)
Press and hold down REWIND + FASTFORWARD
simultaneously until the URC-8350's LED (red light)
blinks twice (the LED will blink once and then twice).
Press 9 7 5 (the LED will blink twice).
Press the device key (on the URC-8350 remote) to
select the mode to which you want to copy the learned
function (example: TV key).
Press the key (on the URC-8350 remote) where you
want to place the learned function (example: LAST key).
The LED will flash rapidly.
Press and hold the key (on your original remote) that
you want to copy until the LED on the URC-8350 blinks
twice (example: "mono/stereo" key).
To exit the learning mode, press and hold OK until the
LED blinks twice.
7