Ericsson EF738 Service Manual page 47

Test/Service Programs
4. Check that the phone is connected to the PC with a fully charged battery as
5. Click Start to enter the flashing dialogue.
6. Press the On/Off-key on the phone and click immediately Start to start flashing.
7. After completion, click OK to confirm SUCCESSFUL FLASHING!, disconnect
8. Exit the EMMA flash program.
Note! If the flash programming is not succesful or has become interrupted during
the flashing process, the flash connector and phone battery have to be disconnected
and reconnected before the flashing can be resumed.
46
described on previous page.
If required, a Com Port different to the default port can be temporarily selected.
The baud rate, 9600, is controlled by the program and can not be manu-ally
altered.
Transfering hex load file is displayed.
The flash memory is erased after which the actual flash programming process is
begun and also displayed by a graph.
the phone and, if required, connect an identical phone, and repeat the procedure
as from step 5.