Table of Contents
Advertisement
1
7. GENERAL INFORMATION
7.1 DIAGNOSIS
7.1.1 DISASSEMBLY
A
Note:
When disassembling a product, be sure to set the PU unit short circuit switch to the short circuit direction.
The vertical and horizontal specifications of a product are switched by switching the spring hooking position using
an arm. At normal assembly and disassembly, the arm switches the position at the position which conforms to the
horizontal specifications. However, because this product conforms to the vertical specifications, take notice not to
forget the changeover.
The changeover position and method are as follows:
Because a changeover arm is provided in the hole near by the center of the product left and right sides, use the
arm to switch the position. For the confirmation of the position, because H and V are marked on the top case.
Accordingly, to assemble a product, adjust H and V conforming to the installation specifications of the product.
B
-
Removing the Upper Case (Fig.1)
1
Remove the screw.
2
Remove the eight screws and then
remove the Upper Case.
C
D
-
Removing the DVD/CD Mechanism Unit (Fig.2)
1
Remove the four dampers.
2
remove the two springs.
Disconnect the connector and then remove the
E
DVD/CD Mechanism Unit.
-
Removing the Grille Assy (Fig.2)
3
Remove the two screws.
Disconnect the connector and then remove
the Grille Assy.
F
92
1
2
2
2
2
2
1
2
1
3
XDV-M8357ZT/UC
2
3
Upper Case
DVD/CD Mechanism Unit
Grille Assy
3
4
2
1
2
2
2
Fig.1
1
2
1
3
Fig.2
4
Advertisement
Table of Contents
