Table of Contents
Advertisement
FIRMWARE RENEWAL MODE
This function allows to upgrade new DVD software from an inserted disc. You should follow
below procedure:
1. Start the DVD player.
2. Insert a upgrade CD with the filename "build.img" and "update.ver" for player.
3. Once the upgrade disci s inserted, the contents of the disc will be read. Display on screen
as below.
Firmware Upgrade
Erase and programme
OK
Cancel
4. Then select "ok", the OSD change to
Firmware Upgrade
Programming, please wait...
the display (LED) will always show the "CDUPD" messages。
5. Then the tray will open automatically. Take out the upgrade disc at once, please.
6. Waiting for the tray close and go to standby. Then, upgrade is complete.
7. Check the version of software (Res. section :MODE FOR SERVICE -1.1) whether it is
same as marked on upgrade disc. If it is, upgrade is successful. If not, ensure update disc is
right and do above process again.
Reminder: The upgrading time should not take more than 5 minutes .DO NOT unplug
the set until upgrade is finished.
Page 21 of 51
Advertisement
Table of Contents
