Related Manuals for Pyle PLINV1
Summary of Contents for Pyle PLINV1
- Page 1 OWNER’S MANUAL POWER INVERTER PINV1 150WATT PINV2 300WATT PINV3 400WATT PINV1 PINV2 PINV3 www.pyleaudio.com...
- Page 2 INTRODUCTION Thank you for purchasing the PYLE View DC to AC Power Inverter. The PINV1/PINV2/PINV3 will deliver an efficient power to a wide variety of household AC products or electronic appliance reliably from the 12 volt outlet in your vehicle or boat, or directly from a 12 Volt battery to serve such as most TVs, VCRs, Play Stations, Work Lights, Soldering Irons, etc.
- Page 3 FEATURES PINV1 1. AC OUTLET 2. ON/OFF SWITCH 3. POWER ON LED 4. PROTECTION LED 5. LIGHTER PLUG PINV2 / PINV3 1. AC OUTLET 2. ON/OFF SWITCH 3. POWER ON LED 4. PROTECTION LED 5. BINDING POST TERMINAL...
-
Page 4: Operation
OPERATION - CAUTION : DO NOT USE THIS INVERTER WITH THE FOLLOWING: • Small battery operated appliances such as RECHARGEABLE FLASHLIGHTS, SOME RECHARGEABLE SHAVERS and NIGHT LIGHTS that are plugged directly into as RECEPTACLE TO RECHARGE • BATTERY CHARGERS used with certain power tool battery packs. These chargers will have a WARNING LABEL stating that DANGEROUS VOLTAGE ARE PRESENT AT THE CHARGERS BATTERY TERMINALS. - Page 5 -The LED indicators A. GREEN : It indicates the inverter is power on, the cooling fan (PINV2 / PINV3) is also activated, and AC power will be delivered to the AC outlet. B. RED : It indicates the inverter shutdown caused by low voltage, overload, or excessive temperature. -The ON/OFF switch It enables output AC power at the AC outlet when switched ON.
- Page 6 BATTERY OPERATING TIME The operating time of battery will vary depending on the charge level of the battery, its capacity and the power level drawn by the particular AC load. The operating time of two to three hours can be expected with a 100 to 150 Watt load;...
-
Page 7: Troubleshooting
TROUBLE SHOOTING SYMPTOM A: NO AC POWER OUTPUT, THE RED LED LIGHTS. POSSIBLE CAUSES The connected AC products are rated at more than 150 Watts (PINV1) , 300 Watts (PINV2) or 400 Watts (PINV3), the overload shutdown occurred. The connected AC products are rated at less than 150 Watts (PINV1) , 300 Watts (PINV2) or 400 Watts (PINV3), the high starting surge causes the overload shutdown. - Page 8 SYMPTOM C: THE LOW OUTPUT OF INVERTER IS MEASURED POSSIBLE CAUSES Battery voltage is too low below 10V DC The inverter is overload SYMPTOM D: THE LOW BATTERY IS MEASURED POSSIBLE CAUSES The poor battery condition Inadequate power of excessive voltage drop SUGGESTION Recharge battery Reduce load to 150 Watts (PINV1) , 300...
-
Page 9: Specifications
SPECIFICATIONS AC output voltage (nominal) ...115 Volts AC DC input voltage range...10-15 Volts DC Maximum Continuous AC output power..150 Watts (PINV1) ...300 Watts (PINV2) ...400 Watts (PINV3) Maximum AC output surge power ...300 Watts (PINV1) ...600 Watts (PINV2) ...800 Watts (PINV3) AC output frequency...60 Hz +/- 2 Hz AC output waveform ...modified sine wave No load current draw ...less than 0.3A (PINV1)