Related Manuals for Pyle PINV5
Summary of Contents for Pyle PINV5
- Page 1 OWNER’S MANUAL POWER INVERTER PINV4 600WATT PINV5 800WATT PINV6 1000WATT PINV4 PINV5 PINV6 www.pyleaudio.com...
- Page 2 Treat it with the same respect that you would do to any AC outlet. • The PINV4 / PINV5 / PINV6 is designed for indoor use only and not recommended for use with inductive loads, such as florescent lamps, compressors & pumps.
- Page 3 FEATURES PINV4 / PINV5 / PINV6 1. AC OUTLET 2. ON/OFF SWITCH 3. POWER ON LED 4. PROTECTION LED 5. BINDING POST TERMINAL...
-
Page 4: Operation
With this lighter plug, the inverter can power loads up to 600 Watts. When continuously powering loads rated higher than 600 Watts, connect the inverter directly to a 12 Volt battery, please use the provided battery clip cables (PINV4/ PINV5/ PINV6) to connect the inverter directly to the 12 Volt power source. - Page 5 When operated from the directly connection to a 12 Volt battery (PINV4 / PINV5 / PINV6) Any combination of 115 Volt AC products with a total power consumption of 600 Watts or less for PINV4 / PINV5 / PINV6 CAUTION: •...
- Page 6 BATTERY OPERATING TIME The vehicle batteries are not intended for constant deep discharge, they are designed to provide brief periods of very high current needed for engine starting. It is strongly recommended to start the vehicle every hour or two to recharge battery before its capacity drops too low. Operating the inverter from a vehicle battery until the low voltage alarm sounds will shorten the battery's life.
-
Page 7: Troubleshooting
(PINV4) , 800 Watts (PINV5) or 1000 Watts (PINV6), the overload shutdown occurred. The connected AC products are rated at less than 600 Watts (PINV4) , 800 Watts (PINV5) or 1000 Watts (PINV6), the high starting surge causes the overload shutdown. The battery is discharged (alarm sounds) The inverter overheated SYMPTOM B: NO AC POWER OUTPUT, NO LED LIGHTS ARE ON. - Page 8 The poor battery condition Inadequate power of excessive voltage drop SUGGESTION Recharge battery Reduce load to 600 Watts (PINV4) , 800 Watts (PINV5) and 1000 Watts (PINV6) maximum to maintain regulation. SUGGESTION Recharge battery Check condition of battery clips and...
-
Page 9: Specifications
No load current draw ...less than 0.7A (PINV4) ...less than 0.9A (PINV5) ...less than 0.9A (PINV6) Input current..50 - 55 AMP (PINV4) ...65 - 70 AMP (PINV5) ...80 - 85 AMP (PINV6) Optimum efficiency ...90% Ambient operating temperature range...0˚C-40˚C/32˚F-100˚F Low battery alarm trigger point (nominal) ...10.5 Volts...