11 Troubleshooting
Danger
First pull out the plug from the mains before carrying
out any tasks on the machine.
11.1 Suction turbine does not run
Turn on the appliance.
Container (in wet vacuuming mode) is full.
Empty the container.
Check cables, plugs and mains supply.
Check/replace the appliance switch.
Check/clean the electrode overflow fuse.
Check/replace the suction turbine.
Check/replace the PCB.
11.2 The suction turbine will not switch off
during wet vacuum cycles when the
container is full.
Check/clean the electrode overflow fuse.
Check the fluid level with non-conductive fluid.
Use the upgrade kit for "non-conductive media".
Check/replace the PCB.
11.3 Suction turbine turns off
Empty the container.
11.4 Suction turbine does not start again af-
ter the container has been emptied
Turn off the appliance and wait for 5 seconds, turn
it on again after 5 seconds.
Clean the electrodes as well as the space be-
tween the electrodes.
11.5 Suction capacity decreases
Remove blockages in the suction nozzle, suction
tube, suction hose, or flat pleated filter.
Exchange the paper filter bag.
Ensure the filter cover properly locks into place.
Check suction system to see if there are any
leaks/repair leaks.
Replace the flat pleated filter.
11.6 Dust comes out while vacuuming
Check for proper installation of the flat pleated fil-
ter.
Replace the flat pleated filter.
11.7 Automatic shut-off (wet vacuum clean-
ing) does not react
Check/clean the electrode overflow fuse.
Continuously check the filling level in case of non-
conductive liquid.
English 5.906-520.0 Rev. 00 (03/12)
27