Subaru IMPREZA 2004 Service Manual page 265

• LHD MODEL
• RHD MODEL
9) Disconnect the grommet from toe board.
NOTE:
From inside compartment, push the grommet (A)
into hole.
10) Pull out the cable from toe board hole.
11) Disconnect the accelerator cable bushing from
accelerator pedal lever.
(A) Flat tip screwdriver
Accelerator Pedal
12) Disconnect the accelerator cable stopper (A)
from bracket.
SP-00018
13) Separate the accelerator cable and bracket.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
• If the cable clamp is damaged, replace it with a
new one.
• Never fail to cover the outer cable end with boot.
• Be careful not to kink the accelerator cable.
• For tightening torque, refer to "COMPONENT".
<Ref. to SP(H4SO)-2, COMPONENT, General De-
SP-00007
scription.>
C: DISASSEMBLY
1) Remove the clip, and then remove the accelera-
tor pedal from bracket.
2) Pull out the spring pin, and then remove the ac-
celerator pedal from accelerator pedal lever.
SP-00008
SP-00009
SP(H4SO)-5
SPEED CONTROL SYSTEMS
SP-00010