Configuring Fcoe; Enabling Fcoe; Cisco Nexus 7000: Enabling Fcoe - Cisco Nexus 7000 series Configuration Manual

Configuring FCoE

• In Cisco MDS NX-OS Release 5.2(x), you cannot install a FCoE module in a switch that is running

Configuring FCoE

Enabling FCoE

Cisco Nexus 7000: Enabling FCoE

You must install the FCoE feature set in the default VDC and enable dependent features in order to enable
FCoE in a storage VDC.
Before You Begin
• Ensure you are in the default VDC.
• Ensure you have installed the correct license for your switch.
• Do not enable FCoE on VLAN 1 or the native VLAN.
SUMMARY STEPS
1. configure terminal
2. install feature-set fcoe
3. feature lldp
4. (Optional) feature lacp
5. system qos
6. service-policy type network-qos policy-name
7. (Optional) show feature
8. (Optional) copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
install feature-set fcoe
Example:
switch(config)# install feature-set fcoe
Cisco NX-OS FCoE Configuration Guide for Nexus 7000 and MDS 9500
10
DMM, SME, or IOA.
Purpose
Enters configuration mode.
Installs the FCoE feature set in the default VDC.
FCoE
OL-25809-02