Care And Maintenance - DeWalt DXAEC210 Instruction Manual

3. Some household USB-powered electronics will not operate with
this unit.
USING THE USB PORT
1. Plug the battery charger's AC Power Cord into a functioning
AC outlet. A beep will sound and the LCD Screen will show the
following:
The empty Battery Icon will light solid to indicate the Battery Clamps
are not yet connected to a battery.
2. Press the USB Power Button to turn on the USB Port. A beep will
sound, the USB Power/Fault Indicator around the USB Port will light
blue and the LCD Screen will continuously display the following:
The USB Icon will light solid, indicating the USB port is ready to use.
3. Plug the USB-powered device into the USB power port and operate
normally.
4. Press the USB power button again to turn off the USB Ports.
DXAEC210_ManualENFRSP_092116.indd 23
AC Pass Through
This unit features a 120V AC Pass Through. When using this feature,
follow all instructions and warnings found in the "Specific Safety
Instructions for the AC Pass Through" in the front of this Instruction
Manual.
NOTE: The 120V AC Pass Through is protected by a circuit breaker
located on the back of the unit (see Fig. 1). If the 120V AC Pass Through
shuts down when it is in use, this circuit break may need to be reset.
Do this by pushing it back into the unit until it locks in place. Refer to
the "Troubleshooting" sections for more information.

Care and Maintenance

WARNING: To reduce the risk of electric shock, unplug the battery
charger from the outlet before attempting any maintenance or cleaning.
Turning off the controls will not reduce this risk.
CLEANING AND STORAGE
• Store the unit in a clean, dry, cool place when not in use.
• Clean the unit casing and cords (as necessary) with a dry (or slightly
damp) cloth. Ensure that unit is completely disconnected from battery
and power source before cleaning.
• To maintain the operating condition and maximize the life of the
charger cords, always coil them loosely on the built-in storage spool
when not in use. Do not wrap them around the unit or crimp them
with a tight band.
23
10/19/2016 3:58:55 PM