DeWalt DXAEC210 Instruction Manual page 18

NOTES:
A. The maximum output current is approximately 70A.
B. If the battery is already charged to nearly full capacity, the
unit's output current may be automatically reduced by a few
amperes, despite the maximum output current rating of 70A.
C. The charging process will start automatically approximately
one minute after the unit is properly connected to a battery if
no other actions are taken.
D. The charging process can be terminated by pressing the
Battery Charge Button again to stop the function. The unit
will revert to the Standby Mode. It will automatically restart the
charging process after approximately one minute if no other
actions are taken.
E. In Charging Mode, the Digital Display shows the output
current (A) that is charging the battery by default. Press the
Battery Voltage Button once to show the voltage (V) of the
connected battery. Press the Battery Voltage Button again to
show the charge status of the battery as a percentage (%)
of full. Pressing the Voltage Button cycles through different
charging status views of the connected battery.
F. Once the unit is in Charging Mode, the Battery Type cannot
be modified. To change Battery Type, terminate the charging
process and then reselect in Standby Mode.
4. When the battery is completely charged, the unit automatically goes
into Float Charge Mode. In this mode, the unit monitors the battery
voltage and charges as necessary to assure the battery maintains
a full charge. The unit remains in Float Charge Mode as long as the
DXAEC210_ManualENFRSP_092116.indd 17
charger is connected to the battery and plugged into a functioning
AC outlet. The LCD Screen shows the following:
The Digital Display shows "FLO" indicating that the unit is in Float
Charge Mode. The Clamp Icons, the Battery Icon (with three bars),
and the Battery Type Indicator will light solid.
NOTE: In Float Charge Mode, the Digital Display shows "FLO" by
default. Press the Battery Voltage Button once to show the voltage
(V) of the connected battery. Press the Battery Voltage Button again
to show the charge status of the battery as a percentage (%) of
full. Pressing the Voltage Button cycles through different charging
status views of the connected battery.
When the unit is in Float Charge Mode, the Battery Type cannot be
modified. To change Battery Type, terminate the charging process
and then reselect in Standby Mode.
5. When disconnecting the battery charger, unplug the AC Power
Cord, remove the clamp from the vehicle chassis, and then remove
the clamp from the battery terminal.
17
10/19/2016 3:58:54 PM