Pyle PLCD27 Owner's Manual
  1. Manuals
  2. Brands
  3. Pyle Manuals
  4. Car Stereo System
  5. PLCD27
  6. Owner's manual

Pyle PLCD27 Owner's Manual

Car audio hifi system
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
R
PLCD27
WNER'S MANUAL
CD PLAYER
C
a
r
A
u
d
i
o
H
i
f
i
S
y
s
t
e
m

Advertisement

Table of Contents
loading

Related Manuals for Pyle PLCD27

Summary of Contents for Pyle PLCD27

  • Page 1 PLCD27 WNER'S MANUAL CD PLAYER...
  • Page 2 Power Volume play/pause eject clock loud release Volume setting bass setting treble settting balance setting fader setting scan repeat random stop Band Band tuner Direct access tuning Radio wiring Speaker wiring Install the unit Removing the unit...
  • Page 3 To prevent injur y of fire,take the following precautions: Insert the unit unitll it is firmly locked to the main unit, otherwise it may fall out of place when jolted When extending the ignition, memory back up or ground cable, use diameter of 0.75mm(AWG18) or more automotive grade cable to avoid wire deterioration or damage...

  • Page 4: Lcd Display

    POWER ON/ EJECT OFF/VOLUME EJECT PUSH ON/OFF SCAN REPEAT RANDOM STOP SELECT RELEASE SELECT Power Tur ning ON the power Press the [PWR]button. Press to turn on the unit power,Press the button to turn off the unit. Volume PLAY/PAUSE Increasing volume Rotate the [VOL+]button Decreasing Rotate the [VOL-]button...
  • Page 5 Eject Press the [ ]button ,if having adisc in the unit. The disc will be ejected out. Press the [ ]button again, the disc will be load in. In beam mode, press the BD button can enter radio mode. If the disc in the slot, press the EJECT button to eject the disc form the slot and automatically be switched to the radio mode.

  • Page 6: Speaker Mode

    Speaker mode VOLUME TREBLE BASS FADER BALANCE In press mode, VOL is sel function Volume set mode Press SEL button once,display shows VOL , then rotate the volume + button to adjust volume level up.Rotate the volume - button to adjust volume level down.
  • Page 7 Press [TOP]button Select the first track directly In CD mode,press this button, the first track will play. Repeat Press [RPT]button Press the button once to repeat the same track continuously, Press the button twice to repeat the disc continuously, RPT will appear on the LCD display. Random Press [RDM]button Press this button to play all the track inrandom order.
  • Page 8 EJECT PUSH ON/OFF SCAN REPEAT RANDOM STOP SELECT PRESET MEMORY 1-6 Band Selecting band Press BAND button to select among three FM or two AM bands. (FM1-FM2-FM3-AM1-AM2) SEEK- SEEK+ Tune In radio mode: manual tuning: short press button it can select higher frequency station. Short press can select lower frequency station.

  • Page 9: Basic Operation

    MONO LOUD STOP SCAN Loading and replacing the batter y Use one lithium battery(CR2025) insert the batteries with the +and - poles aligned properly. Following the illustration inside the case. Pull out Store unused batteries out of the reach of children. Contact a doctor immediately if the battery is accidentally swallowed.

  • Page 10: Radio Control

    Volume Increasing volume Press the [+]loud VOL Increasing volume Press the [-]low VOL Play/pause Play Press the [ ]button Pause Press the [ ] button again Radio control Page(7) Remote operation the same of mainframe. Exter nal view Exter nal view ...

  • Page 11: Speaker Wiring

    Follow this easy wiring diagram in order to enable you to install the new or existing RADIO and SPEAKER wring system. Be sure the unit is connected to a 12 volts battery with negative ground. Good ground connections eliminate most electrical noise problem and require tight with the metal vehicle chassis.

  • Page 12: Install The Unit

    efore installing the receiver permanently, fit it in the approximate place in your car Connect the equipment according to the speakers and electrical connections. When your system is operated properly,(preferably with the car engine running), follow the instructions for permanent installation of your system.
  • Page 13 Specifications subject to change without notice. CD PLAYER Signal/Noise radio...70dB Frequency response...20Hz-20KHz(+3dB) Channel separation...>45dB Dual D/A converter...16Bit FM Tuner Tuning range...USA:87.5-108MHz EUROPE:87.5-108.0MHz FM usable sensitivity(S/N=30dB)...<12dB Stereo separation...>45dB AM Tuner Tuning range...USA:520-1720KHz EUROPE:522-1620KHz AM sensitivity...28dB GENERAL Operating power...12 Volts DC,negative %10THD output wiring...Designed for using four Load impedance...compatible 4 to 8 ohm...
  • Page 14 What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. ?The power does not tur n ON. The fuse has blown. Install half sleeve, can be with or ?NO Sound.
  • Page 15 CD PLAYER C a r A u d i o H i f i S y s t e m...

Table of Contents