Verizon Smart-Cell User Manual page 29

Check gain of the unit
Cable connector loose
Check input signal
strength in the service
In case of
If input signal strength
dropped call
is not a problem, please
or bad signal
check delay of calling
after set up
Check RSSI signal
Check connection
fastened between
antenna and cable
In case
(Signal wavelength
output
should be flat and
Signal
stable if technicians
wavelength
shake CABLE. If not, it is
is not shown
connection problem)
flat or looks
like Input level change or
oscillation module overheating
Please check VSWR of
the cable is normal
-If the Gain is different from normal level, please
contact A/S team
-It is possible for connectors to get too tight and
damage the equipment or throughput
-Please contact installer or service provider upon
verification
-Increase output power level of repeater by
adjusting attenuation level
area
-Increase output level of Uplink signal, then set to
optimal level.
time
-Contact network management team or service
strength provider
-If connection is not proper, reconnect cable and
connector and then check the output power again
-Check input level from BTS side.
-Check performance of each module (Diagnosed
by A/S team)
-Change to normal Cable
29
Verizon User Manual
Smart-Cell Repeater