Pride Mobility Power Lift Recliner Series Owner's Manual page 13

I V. A S S E M B L Y / D I S A S S E M B L Y
NOTE: Depending on power lift recliner width, you may need to slide on one side of the chair-
back at a time. If this is the case, level the chair-back before pressing down to lock into position.
4.1.3 Drape the hand control and cable over the chair
base, then slide the back onto the base. Ensure the
hand control cable is routed through the rear of the
power lift recliner. Push firmly on the top of the chair-
back to lock into position. Listen for a click on each
side to ensure the chair-back is locked in properly.
NOTE: Pull up on the chair-back to ensure that it is locked in place. If the back can be pulled off,
then repeat steps 4.1.1 through 4.1.3.
HEAT CONNECTION TO JUNCTION BOX
JUNCTION BOX
4.1.5 Connect the heat and massage harnesses to the
junction box. The junction box is mounted to the
back of the power lift recliner. Ensure the hand
control harness is routed through the rear of the
power lift recliner.
Power Lift Recliner Series
"CLICK"
4.1.4 For 107 Power Lift Recliners, tuck the fabric flaps on
MASSAGE
UNIT
4.1.6 Attach the chair-back to the hook and loop flaps on
www.pridemobility.com
ZIP
the front of the chair-back and rear of the chair base
down into the frame and secure with the reusable
fastener on each flap. Then, zip the two sections
together.
the bottom of the chair base.
UNZIP
13