Ac/Dc Power Supply Connection - Motorola RPU2160 Installation And User Manual

AC/DC Power Supply Connection

Each repeater ships standard with an AC/DC
Power supply cord (P/N PMPN4002A)(9 feet
long) that connects the repeater to a (110/120)/
(220/240) Vac source.
Nominal Input: (110/120)/(220/240) Vac at
60/50 Hz.
Average output voltage: 12 Vdc with 2.5 Amp (at
maximum load).
When operating the power supply,
make sure that the maximum input
current never exceeds 0.8 Amp at 100
Important
Vac and ambient temperature is
between -30°C to 60°C.
Provide over voltage/current protection
in order to avoid unsafe operating
conditions.
To connect AC/DC power supply:
Plug the AC/DC power supply into an AC
1.
power source of 110/220 V or a 12 V DC
power and route it to the Repeater Jack
labeled "AC/DC IN".
Note: The cable from the power supply should be
routed in a straight line and should not
tangle, go around or wrap around the
repeater device, the antenna or the RF
Cable. See "Figure 8a. Repeater Cable
Layout Using Dipole Antenna P/N
HKAE4000" on page 19 (Notice in this
picture that the cable must be laid down
straight for at least 2 feet).
Installation Guide
27