Replacing Water System Components
Replacing the water pump
Disconnect electrical power.
Remove the rear cover
Unplug the lines connected to the water pump, the water outlet tube and the water inlet tube.
Loosen the screws and replace with a new one.
Reverse the above steps to reassemble.
Replacing the water inlet valve
Note: If the water inlet valve does not work at all, or does not shut off tightly, it should be
replaced.
Unplug or disconnect electrical power.
Loosen the water supply pipe, remove the water panel, loosen 2 screws holding the water inlet
valve, unplug the lines and loosen the water valve outlet tube.
Replace a new one, reverse the above step to reassemble.
Unscrew the water drain cap and drain off the waste water into a
bucket or other suitable drain port. Next, re-secure the drain cap
and tighten.
18