Replacing The Hepa Filter - Oreck CC1605 Owner's Manual

REPLACING THE HEPA FILTER

Push down the HEPA filter door
tab to pull out
! !
WAR N I N G!
TO REDUCE THE RISK OF PERSONAL INJURY–
UNPLUG BEFORE CLEANING OR SERVICING.
4 . M A INT E N A N C E
Slide the HEPA filter up and out.
Insert a new filter by aligning the
slots on the side of the filter with
the tabs on the filter door.
IF APPLIANCE IS NOT WORKING AS IT SHOULD, HAS BEEN DROPPED,
DAMAGED, LEFT OUTDOORS, OR DROPPED INTO WATER, TAKE IT TO A
SERVICE CENTER PRIOR TO CONTINUING USE.
Place the HEPA filter door back in
until it snaps into place.
ANY OTHER SERVICING SHOULD BE
DONE BY AN AUTHORIZED SERVICE
REPRESENTATIVE.
LUBRICATION
The motor is
equipped with
bearings which
contain sufficient
lubrication for
their lifetime. The
addition of lubricant
could cause damage.
Do not add lubricant
to motor.