Troubleshooting - Philips HTL1030 User Manual

Troubleshooting

WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair.
If you are unable to remedy the problem by following these hints, consult your
dealer or PHILIPS for help.
Problem
No power.
No sound or distorted sound.
The remote control does not function — Reduce the distance between the remote
Properly.
Low hum or buzz sound.
The content of the USB flash drive
cannot be read
Slow operation of the USB Flash
drive
Cannot detect USB flash drive
FM not properly tuned
FM reception not good
Bluetooth
— Check if the AC power cord is properly
inserted into the AC mains socket.
— Adjust the volume.
— Select the correct source
to choose the equipment that you want
to hear through the System.
control and the system.
— Replace the batteries with new ones.
— Point the remote control directly toward the
IR sensor (located on front panel of the
Soundbar).
— Check that the batteries are loaded correctly.
— Switch off system for 30 seconds
and then restart
— Place the product as far away as possible
from electrical devices that may be
causing interference.
— Check power supply voltage and consult
electrician
— The USB flash drive format is not compatible
with the system.
Drive is formatted with a different file system
which is not supported by this unit (e.g. NTFS)
— Large file size of high memory USB flash drive
takes longer time to read and play.
— Take out USB drive insert it again properly.
— Match with local frequency
— While listening radio turn off TV/DVD
or other radiation source.
— Extend antenna wire
— Reduce the distance between system and your
device.
— Re-Pair the device.
9
Solution