GE PS960 Owner's Manual page 29

Troubleshooting Tips ... Before you call for service
Problem
Unable to set cook time or
delay time
Oven racks are difficult
to slide
Drawer does not slide
smoothly or drags
Steam from the vent
Water remaining on oven
floor after Steam Clean
cycle
Oven will not steam clean
Display prompts for Probe
Temperature
49-80808
Possible Cause
You forgot to enter a cooking mode
first.
The shiny, silver-colored racks were
cleaned in a self-clean cycle.
The drawer is out of alignment.
Drawer is over-loaded or load is
unbalanced.
When using the ovens, it is normal
to see steam coming out of the
oven vents. As the number of racks
or amount of food being cooked
increases, the amount of visible
steam will increase.
This is normal.
Display flashes HOT.
Oven controls improperly set.
Oven door is not closed.
This is reminding you to enter a
probe temperature after plugging in
the probe.
What To Do
See the Options section
Apply a small amount of vegetable oil to a paper towel and
not spray with Pam or other lubricant sprays.
®
Fully extend the drawer and push it all the way in See the
Care and cleaning of the range section.
Reduce weight. Redistribute drawer contents.
This is normal.
Remove any remaining water with a dry cloth or sponge.
Allow the oven to cool to room temperature and reset the
controls.
Make sure you close the door to start steam clean cycle.
Enter a probe temperature.
29