Read Otp - Siemens SIMATIC RF310M Operating Instructions Manual

Simatic sensors rfid systems mobile reader

Hide thumbs Also See for SIMATIC RF310M:

Table of Contents

Read complete tag

When reading an RFID tag, the entire tag is read if you select the setting "Complete Tag"

under Read / Write in the "Address Setup" window of "Extras" > "Address Setup>

(<ALT+X+A>):

Figure 6-8

This setting remains in force for all further read/write operations until the values are changed

again. See also Address Setup (Page 45).

6.5.4

Read OTP

You can execute reading of the OTP area of a tag using "Tag > Read OTP" in the menu (or

<ALT+T+E>).

Please observe the limit distances between the tag and the Mobile Reader here too.

Note

Tag cannot be written to after reading of the OTP area

After the OTP area of a tag has been read, the tag cannot be written to. However, the

function "Write OTP" is possible if needed.

Before the tag can be written to again, the menu command "Tag > Read" must be executed.

SIMATIC RF310M Mobile Reader

Operating Instructions, 07/2007, J31069-D0191-U001-A1-7618

"Address Setup" settings for reading the complete tag

SIMATIC RF310M software

6.5 The functions in the "Tag" menu

Table of Contents