SRAM GUIDE RSC 2015 Service Manual page 26

Remove the o-rings from the banjo bolt and banjo fitting.
4
Apply a small amount of DOT 5.1 fluid to the new o-rings and
install them.
5 Insert the banjo bolt through the outboard caliper half.
Apply a small amount of DOT 5.1 fluid to the caliper o-ring and
install it onto the banjo bolt.
Align the banjo fitting with the banjo bolt and thread the bolt, by
6
hand, into the banjo fitting until it stops. Do not tighten the banjo
bolt yet.
Install the caliper body bolt and use a torque wrench with a
7
T25 TORX® bit socket to tighten the bolt to
9.7-11.7 N·m (86-104 in-lb).
T25 TORX 9.7-11.7 N·m (86-104 in-lb)
Caliper Piston Installation
T25 TOR
26