ProForm PFTL59506.0 User Manual page 7

2. With the help of a second person, carefully tip
the treadmill onto its other side. Partially fold the
Frame (58) so the treadmill is more stable. Do
not fully fold the treadmill until it is com-
pletely assembled.
Attach two Base Pads (82) to the base of the
Uprights (84) with two 1" Tek Screws (83) as
shown.
Insert the other Extension Leg (89) into the base
of the Uprights (84) as shown. Hold two
Extension Leg Nuts (67) in the bottom of the
Extension Leg. Next, insert two Extension Leg
Bolts (65) into the top of the Extension Leg, and
firmly tighten the Extension Leg Bolts into the
Extension Leg Nuts.
3. With the help of a second person, carefully raise
the Uprights (84) to a vertical position.
Have the second person hold the console as-
sembly near the Uprights (84) as shown. Look
under the console assembly and locate the con-
sole wire.
Remove the band securing the Wire Harness
(77) to the right Upright (84). Next, connect the
Wire Harness to the Console Wire (66). Make
sure to connect the connectors properly (see
the inset drawing). The connectors should
slide together easily and snap into place. If
the connectors do not slide together easily and
snap into place, turn one connector and then try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON.
4. Insert the Wire Harness (77) and Console Wire
(66) into the right Upright (84).
Set the console assembly on the Uprights (84).
Be careful to avoid pinching the wires. While
a second person holds the console assembly, at-
tach it with four Console Bolts (64) and four Star
Washers (8) as shown; start all four Console
Bolts and then firmly tighten them.
2
82
83
67
3
Console
Assembly
66
77
4
Console
Assembly
77, 66
8
64
84
7
84
65
82
89
58
66
77
84
8
64
84