Adjustment - HYT TC-610 Service Manual

Adjustment

User Mode
Power on the radio to enter the conventional mode when no key is pressed.
Programming Mode
In user mode, the PC programming software triggers the PC programming mode by communication
through a special communication protocol. The programming mode can set functions and
adjustment parameters of the radio via the PC programming software (including user version and
factory version).
Wired Clone Mode
Description
The wired clone mode is a separate mode. To enter other modes, the radio must be turned off and
back on.
The wired clone mode is classified into user wired clone mode and factory wired clone mode.
User Wired Clone Mode
Connect the two radios with the cloning cable. Power on the mother radio while holding down SK2
on it. The radio enters the wired clone mode in two seconds. Power on the slave radio directly and
the radio enters the user mode. The user wired clone mode clones the parameter data in EEPROM
of the mother radio into that of the slave radio. The transferred data only includes channel data and
shared setting parameters, excluding adjustment parameters, model version information, serial
number, etc.
Factory Wired Clone Mode
Short connect the SELF pin of the mother radio's MCU and connect the two radios with the cloning
cable. Power on the mother radio while holding down SK2 on it. The radio enters the wired clone
mode in two seconds. Power on the slave radio directly and the radio enters the user mode. The
transferred data includes all data (excluding the serial number) in EEPROM and the switch icon of
the manual adjustment inhibit.
Process
Wired Clone
1. LED flashes orange once when the mother radio enters the wired clone mode. Press SK2 to
21