MESSAGE
Shift Not Allowed
Press Brake And Try Again
Shift To Neutral
Press Brake Pedal
Press Brake Shift to N key to
start
This message may appear when starting the engine at low temperature. In this case
the Automated Manual transmission isn't able to engage first gear, in this situation
either use the engine block/transmission heater or allow the engine to idle in NEU-
TRAL (N) until the transmission has warmed.
This message appears accompanied, in some cases, by a warning buzzer, if you at-
tempt to change gear with the vehicle parked without pressing the brake pedal.
To shift the transmission (with key on/engine off), press and hold the brake pedal,
move the gear selector to NEUTRAL (N), then move the gear selector to the desired
This message appears, when the gear selector must be moved to the NEUTRAL (N)
When the gear selector is moved to NEUTRAL (N) the message on the display
This message is shown in the display together with an acoustic signal, when the
brake pedal is not pressed during a starting attempt.
This message appears, when the drivers door is first opened, to remind to Press the
Brake pedal and shift the lever in N to permit the cranking.
STARTING AND OPERATING 39
DESCRIPTION
position.
position.
should go off.
4