ProForm DRTL49220 User Manual page 6

3. Identify the Right Handrail (72), which has a large hole in
the left side. Feed the Wire Harness (42) up into the
bracket on the Right Handrail and out of the large hole in
the left side. (Note: It may be helpful to use needlenose
pliers to pull the Wire Harness out of the large hole.)
Press a Handrail Cap (76) onto the lower end of the
Right Handrail as shown. Remove any plastic ties from
the bracket.
Insert the bracket on the Right Handrail (72) into the top
of the right Upright (69) so the Handrail Cap (76) is rest-
ing against the Upright. Attach the Right Handrail and the
Handrail Cap with three 3/4" Bolts (37) and two Washers
(38) as shown. Do not tighten the Bolts yet.
4. Attach the Storage Latch (36) and the Latch Spacer (29)
to the Left Handrail (71) with two 1" Latch Screws (123).
Remove the Latch Knob (30) from the Latch Pin (35).
Make sure that the Latch Pin Collar (33) and the Spring
(32) are on the Latch Pin as shown. Insert the Latch Pin
into the Storage Latch (36) and tighten the Latch Knob
back onto the Latch Pin.
Attach the Left Handrail (71) as described in step 3.
Note: There is not a wire harness on the left side.
5. Attach the end of the ground wire to the small hole in the
side of the Right Handrail (72) with a Silver Ground
Screw (75).
3
Bracket
72
4
71
29
30
5
6
42
Large
Hole
37
38
38
37
69
76
37
36
33
123 32
Ground
75
Wire
72
35