Erasing the entire HomeLink
Before programming
■
Install a new battery in the remote control transmitter.
●
The battery side of the remote control transmitter must be pointed away
●
from the HomeLink
Certification for the garage door opener
■
For vehicles sold in the U.S.A.
• Vehicles with rear view monitor system
FCC ID: NZLGHSHL4
• Vehicles without rear view monitor system
FCC ID: NZLWZLHL4
NOTE:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any inter-
ference received, including interference that may cause undesired opera-
tion.
FCC WARNING:
Changes or modifications not expressly approved by the party responsi-
ble for compliance could void the user's authority to operate the equip-
ment.
For vehicles sold in Canada
NOTE:
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
®
memory (all three programs)
®
.
3-8. Other interior features
Press and hold down the 2 out-
side buttons for 10 seconds until
the indicator flashes.
If you sell your vehicle, be sure to
erase the programs stored in the
®
HomeLink
memory.
3
489