Symmetricom SSU-2000e User Manual page 101

3. Type
RTRV-SEC-LOG:::123::10;
events.
Changing a User's Password
1. Type
SET-USER:::123::PWD,username,password;
the specified user.
2. Type
SET-PWD-CONFIRM:::123::password;
must issue the SET-PWD-CONFIRM command immediately after the SET-USER
command in order to validate the SET-USER command.
Setting a Temporary Password
An Administrator-level user can create a temporary password for a user. When a
user logs in using the temporary password, that user must create a new password
before continuing.
1. Type
SET-USER:::123::TMP,username,pwd;
for the specified user.
2. Type
SET-PWD-CONFIRM:::123::pwd;
must issue the SET-PWD-CONFIRM command immediately after the SET-USER
command in order to validate the SET-USER command.
Changing a User's Access Level
Type
SET-USER:::123::ACC,username,,level;
the specified user.
Deleting a User
Type
SET-USER:::123::DEL,username;
table.
Enabling, Disabling, and Unlocking Users
An Administrator-level user can enable or disable a user from accessing the
SSU-2000e without removing the user name from the user table. If a user exceeds
the number of failed attempts to log in, then the user name is locked for a period of
time. An Administrator-level user can unlock the user name and allow the user to
attempt to log in, overriding the Lockout Time parameter.
1. Type
SET-USER:::123::DIS,username;
accessing the SSU-2000e.
2. Type
SET-USER:::123::ENA,username;
SSU-2000e.
3. Type
SET-USER:::123::UNL,username;
12713140-002-2 Revision E – October 2006
Chapter 3 Provisioning and Operating the SSU-2000e
to display the 10 most recent security log
to change the password for
to confirm the new password. You
to create a temporary password
to confirm the temporary password. You
to change the access level for
to delete the specified user from the user
to disable the specified user from
to allow a user to access the
to unlock a user name.
Setting Security Parameters
SSU-2000e User's Guide 101