Troubleshooting - Icom IC-M85 Instruction Manual

12

TROUBLESHOOTING

PROBLEM
The transceiver does
not turn ON.
Little or no sound
comes from the
speaker.
You cannot transmit,
or cannot select high
power.
Scan does not start.
No beep sounds.
The keypad and [DIAL]
does not work.
29
POSSIBLE CAUSE
• The battery is exhausted.
• The battery pack is not correctly attached.
• Squelch level is set too high.
• Volume level is set too low.
• The speaker has been exposed to water.
• Some channels are set for low power or
receive only by regulations.
• The output power is set to low.
• More than 2 favorite channels are not set.
• The Key Beep function is OFF.
• The keypad and [DIAL] is locked.
SOLUTION
• Recharge the battery pack.
• Correctly reattach the battery pack.
• Adjust the squelch level.
• Adjust the volume level.
• Use the AquaQuake Water Draining
function to remove water from the
speaker grill.
• Change channels.
• Push [H/L] to select high power.
• Set the Favorite channels.
• Turn ON the Key Beep function.
• Hold down [ ] for 1 second to lock or
unlock the keypad.
REF.
p. 9
p. 3
p. 14
p. 5
p. 14
p. 11
p. 5
p. 16
p. 20
p. 5