ProForm 785ss PFTL79103 User Manual page 8

If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re-
ceiver and the short jumper wire included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated Console Back Screws (87) from the
Console Back (88). Remove the Console Back from the
Console Base (81).
2. Connect the short jumper wire (A) to the wire on the re-
ceiver (B). Connect the other end of the short jumper wire
to the PULSE jack on the back of the Console (see draw-
ing 2b). Note: If there is a wire already plugged into the
PULSE jack, unplug it.
Next, peel the paper off the pad on the back of the receiver
(B). Turn the receiver so the small cylinder is on the
side shown, and press the receiver into the bottom of the
Console Base (81) in the indicated location. Use the in-
cluded wire tie to tie wires if needed. Note: The other wires
included with the receiver may be discarded.
Make sure that no wires are pinched. See step 1.
Reattach the Console Back (88) with the Console Back
Screws (87).
1
2a
A
Cylinder
B
8
88
87
2b
81
PULSE
Jack
81