Table of Contents
Advertisement
To access the configuration menu, press the [FUNC] key, and then press the [kHz] key.
Press the [DOWN] key five times to select "UNIT" in reverse contrast.
Rotate the sub dial to select either dBm or dBu.
Press the [MHz] key to accept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry.
Or, press the [DOWN] key to move to the next item on the configuration menu.
9-7 CONFIGURE ANT PROGRAM
The AR6000 has two antenna input ports and may be assigned according to the receive frequencies.
Note: 1. When the receiving frequency is below 25 MHz, antenna 2 must be used.
2. When the optional (external) antenna relay switch is connected,
Configuring example:
To configure the antenna program, perform the following steps:
1. Press the [FUNC] key, and then press the [kHz] key.
2. Press the [DOWN] key six times to go to "Configuration 2/3" and select "ANT PROGRAM" in
reverse contrast.
3. Press the [MHz] key.
4. Rotate the main dial to select Antenna 1.
5. Rotate the sub dial to select the desired program number 0.
If the programmed channel is empty, "----.------" is displayed.
To delete the current channel, press the [PASS] key.
6. Press the [1], [0], [0], [MHz] key to enter the upper limit frequency.
up to 4 antennas may be used.
Antenna 1:
25 MHz ~ 100 MHz
Antenna 2: 200 MHz ~ 300 MHz
64
Advertisement
Table of Contents
