ProForm 2500 PFTL49720 User Manual page 7

4. Loosely thread a 1/2" Tek Screw (116) into the left side of
the Crossbar (46).
5. Tighten tighten a 3/4" Tek Screw (35) into the right side of
the Crossbar (46) and the Right Upright (55).
Attach the Console Base (38) to the Uprights (55, 64) with
four 1/2" Screws (33). Make sure that the Wire Harness
(49) is not pinched.
6. Tighten the 1/2" Tek Screw (116) in the left side of the
Crossbar (46).
Orient one of the Handgrip Extensions (34) as shown and
insert it as far as possible into the post on the left Upright
(64). If necessary, tap the Handgrip Extension with a rub-
ber mallet to fully insert it. Attach the Handgrip Extension
with two 3/4" Tek Screws (35), one towards the front of
the post, and the other towards the back.
Attach the other Handgrip Extension to the post on the
right Upright (not shown) in the same way.
7. See the inset drawing. Identify the Left Top Handgrip
(31); there are identifying marks inside the Handgrips. Set
the Left Top Handgrip on the left Handgrip Extension
(34). Insert two 1/2" Screws (33) into the two holes in
the Handgrip Extension indicated by the arrows.
Tighten the Screws into the Left Top Handgrip.
Important: Do not tighten the Screws into the plastic
bosses on the bottom of the Left Top Handgrip.
4
116
(Leave loose)
5
49
33
6
34
7
Bosses
33
34
64
7
46
38
46
35
55
33
64
46
116
35
Post
64
31
31
43
35