Advertisement
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
*
3
When you stand the unit, be careful not to damage the fuse on the rear.
When using the optional stay
Dashboard
Install the unit at an angle of less than 30˚.
Removing the unit
Before removing the unit, release the rear section.
When installing the unit without using the sleeve
In a Toyota car for example, first remove the car radio and install the unit in its place.
Stay (option)
Fire wall
Screw (option)
Note
Do the required electrical connections.
Flat type screws (M5 × 8 mm)
*
4
*
4
Bracket
Pocket
: When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws
are used, they could damage the unit.
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
2
Bend the appropriate tabs to hold the
sleeve firmly in place.
*
4
Not supplied for this unit.
Flat type screws (M5 × 8 mm)
Bracket
*
4
*
4
Advertisement
