Using the Module Bay
3. Close the display and turn the computer over.
4. Use a #1 Phillips screwdriver to remove the device screw from the bottom of the computer.
1
device latch release
5. Press the device latch release so that the latch release pops out.
6. Pull the device by the latch release to remove the device from the module bay.
7. Insert the new device into the bay, push the device until you feel a click, and push the device latch
release in so that it is flush with the computer.
8. Replace the device screw.
9. Turn on the computer.
file://C:\Documents%20and%20Settings\rpaxman\Local%20Settings\Temp\~hh433D.htm
Page 4 of 12
9/19/2003