Polaris RANGER XP 1000 2018 Service Manual page 387

6. Install the LH output hub
housing. The output hub should spin freely.
7. Install the torsion spring by wrapping each leg of the
spring around the dowel pin on the ring gear.
8. Install the rollers and roll cage into the ring gear.
Insert the rollers as the roll cage is installed.
a
9. Install the pins , roll cage
i
assembly into the gearcase housing.
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
s
into the gearcase 10. Align the spring retainer dowel pin with the ring gear
11. Check the action of the torsion spring by rotating in
12. Install the armature plates
o
, and ring gear
dowel pin and install the retainer
torsion spring.
both directions to ensure the spring and retainer are
installed properly.
t
plate tabs are fully engaged into the roll cage
assembly.
NOTE
Verify armature plate tabs are in the slots on the roll
cage and are resting in the ring gear grooves.
FINAL DRIVE
y
on top of the
. Be sure the armature
7
7.35