Ericsson R280d User Manual page 14

3 Hold the small plug on the charger cord so the light-
ning bolt symbol ( ) is up.
4 Align the small plug on the charger cord with the con-
nector on the bottom of your phone. The connector
on the phone is above the lightning bolt symbol ( ).
5 Press the plug into the connector until the plug
"snaps" into place. The
the icon.
Note! Do not twist while inserting or removing the small plug
on the charger cord!
6 Continue charging the phone until the battery is fully
charged.
7 To disconnect the charger, lift the plug connected to
the phone upwards and pull it out.
8
icon is alternated with
Charge-Only Mode
If your phone is off, attaching the charger will cause the
phone to activate in charge-only mode. When this mode
is activated the message Charging Only appears in
the display. Your phone is now fast (rapid) charging the
battery. When your phone is fully charged, Battery
Charged appears in the display.
Note! You cannot make or receive calls when your phone is in
charge-only mode.
Slow (Trickle) Charging a Deeply
Discharged Battery
The battery may become deeply discharged (for exam-
ple, when the battery is stored for a long period). As a
result, the phone may not immediately activate charge-
only mode when the charger is connected.
1 Attach the charger to the phone for several hours to
slowly charge (trickle charge) the battery.
2 After trickle charging the battery for several hours the
phone should activate the charge-only mode automati-
cally.
3 Continue charging the phone until the battery is fully
charged.
Note! If the phone is powered On and the phone is charging,
the icon is alternated with the
fully charged, the icon remains constant.
icon. When
Getting Started