Features And Controls - Briggs & Stratton 130000 Operator's Manual

Features and Controls

Match the call out letters in Figure 2 to the features and controls listed in the accompanying table.
2
Control Symbols and Meanings
A Auger Control Lever - Used to engage and
disengage the auger and impeller.
B Speed Selector Lever - Allows the operator to
select forward and reverse speeds.
NOTICE
Traction Control is engaged. This may result in
severe damage to the drive shaft.
C Deflector Control - In-Dash - Used to control the
angle of the deflector (up or down).
D Chute Rotation Crank - In-Dash - Used to rotate
the discharge chute to the left or right.
Do not move speed select lever while
E Free Hand™ Feature - After engaging the traction
control (right hand), allows the operator to release
the auger control lever to use other controls.
F Traction Control Lever - Used to propel
snowthrower forward or reverse. See also
"Free-Hand Feature".
G Clean-Out Tool - Used to remove snow and
debris from the discharge chute and the auger
housing.
H Skid Shoes - Used to adjust the ground clearance
of the auger housing.
5