Connecting To Weld Output Terminals - Miller Trailblazer 302 Diesel Owner's Manual

5-7. Connecting to Weld Output Terminals

1
7
4
5
6
Correct Installation
OM-217 454 Page 16
Do not place
anything between
weld cable terminal
and copper bar.
2
3
Incorrect Installation
Y Do not connect to CC and CV
terminals at the same time.
1 Work Weld Output Terminal
2 Stick/TIG (CC) Weld Output
Terminal
3 Wire /CV Weld Output Terminal
For MIG welding, connect work cable
to Work terminal and wire feeder
cable to Wire (CV) terminal.
For Stick/TIG welding, connect work
cable to Work terminal and electrode
holder/TIG torch cable to Stick/TIG
(CC) terminal.
Use Process Selector switch to
select type of weld output (see
Section 6-3).
Y Failure to properly connect
weld cables may cause exces-
sive heat and start a fire, or
damage your machine.
4 Weld Output Terminal
5 Supplied Weld Output Terminal
Nut
6 Weld Cable Terminal
7 Copper Bar
Remove supplied nut from weld out-
put terminal. Slide weld cable terminal
onto weld output terminal and secure
with nut so that weld cable terminal is
tight against copper bar. Do not
place anything between weld cable
terminal and copper bar. Make
sure that the surfaces of the weld
cable terminal and copper bar are
clean.
Tools Needed:
3/4 in
804 195-A / Ref. 216 171-A/ 803 778-A