Emergency Starting - Mercury 25 TwoStroke Operation, Maintenance And Installation Manual

4. Remote control models: Place the remote control lever at Neutral (N) and
idle the engine.
5. Turn the key to the off position, or pull the lanyard stop switch.
a
IMPORTANT: Follow the instructions below.
•
After the engine stops, tighten the air vent screw on the tank cap.
•
Disconnect the fuel connector from the engine.
•
For electric start models, disconnect the cables from the battery
when not in use for extended periods.

Emergency Starting

If the starter system fails, use the spare starter rope (provided) and follow
procedure.
1. Ensure the lanyard stop switch is in run position.
OPERATION
N
c
b
48
37882
a - Hook
b - Off
c - On
d - Lanyard stop switch
d
37716
eng