Installing the rotary commander
Notes
• Choose the mounting location carefully so the
rotary commander will not interfere with
operating the car.
• Do not install the rotary commander in a place
where it may jeopardize the safety of the (front)
passenger in any way.
• When installing the rotary commander, be sure
not to damage any electrical cables etc. on the
other side of the mounting surface.
• Avoid installing the rotary commander where it
may be subject to high temperatures, such as
from direct sunlight or hot air from the heater
etc.
1
Choose the exact location for mounting the rotary
commander, then clean the mounting surface.
Dirt and oil impair the adhesive strength of the double-sided
adhesive tape.
2
Mark the position for the supplied screw.
Use the screw holes on the mounting hardware 9 to mark
the position.
3
Remove the steering wheel column cover, and drill 2 mm
(
3
/
in.) diameter hole at the marked position.
32
4
Warm the mounting surface and the double-sided adhesive tape on the mounting
hardware 9 to a temperature of 20°C (68°F) to 30°C (86°F), and attach the mounting
hardware to the mounting surface applying even pressure. Use the supplied screw 8
to set into secure position.
Attach a piece of heavy duty tape etc. on the other side of the mounting surface to cover the
protruding tips of the screws so they will not interfere with any electrical cables etc. inside the
steering wheel column.
Cut the mounting hardware 9, If necessary.
9
8
5
After reinstalling the steering wheel column cover, attach the rotary commander to
the mounting hardware by aligning the four holes on the bottom of the rotary
commander with the four catches on the mounting hardware and sliding the rotary
commander until it locks into place as illustrated.
Note
If you are mounting the rotary commander on the steering wheel column, make sure that the
protruding tips of the screws on the inner surface of the column do not in any way hinder or
interfere with the movement of the rotating shaft, operative parts of the switches or the
electrical cables etc. inside the column.
Holes
Example of a mounting location
9
Mark
Heavy duty tape etc.
FM/AM
Cassette Car
Stereo
Installation/Connections
R
XR-C9100
Sony Corporation © 1998
Parts for installation and connections
The numbers in the list are keyed to those in the instructions.
1
2
5
6
9
!º
After connecting, bundle up the connecting cord of the rotary
commander with other connecting cords of the audio equipment by
attaching the supplied cramper !¡. Be sure to leave some slack in the
connecting cord between the plug and the cramper.
Caution
Cautionary notice for handling the bracket 1.
Handle the bracket carefully to avoid injuring your fingers.
Printed in Japan
4
3
× 2
× 4
7
8
!¡
!¡
*I-3-864-309-11*
(1)